How to extend the life of Antminers?

Here are some suggestions to help you better operate and maintain miners.

1. It is recommended to use the original cooling fan because the quality is guaranteed.

2. Low-speed fans cannot replace high-speed fans, but high-speed fans can replace low-speed fans.

3. Regular dust removal is essential. Don't disassemble the miner. Instead, use the dust removal fan to clean the fan every other month according to the air quality.

4. Reducing noise usually requires lowering the fan speed, affecting heat dissipation. Therefore, this is not recommended. However, in the future, more Antminer models may try water cooling.

5. Antminer is not recommended to dissipate heat in oil.

6. The best indoor temperature for miner operation is 20-30℃.

7. The temperature of the chip should be controlled at about 70-80°C. The accumulation of dust may cause overheating.

8. As for the problem of low chip temperature, if the miner runs normally, the fan will run at a low speed and the power consumption will be lower.

9. Closely monitor the temperature of the miners. If something goes wrong, please pause. The temperature difference of the hash board should be within 10°C.

10. There are many reasons for the drop in hash speed. HW refers to the hardware error rate, which will cause miners to restart in a certain proportion. If the problem occurs frequently, it is recommended to request maintenance.

8. As for the problem of low chip temperature, if the miner runs normally,  the fan will run at a low speed, and the power consumption will be lower.

9. Closely monitor the temperature of the miners. If something goes wrong, please pause. The temperature difference of the hash board should be within 10°C.

10. There are many reasons for the decrease in hash rate speed. HW refers to the hardware error rate, which will cause miners to restart in a particular proportion. If the problem occurs frequently, it is recommended to request maintenance.

11. Even if one of the hash boards is damaged, the miner can still run, affecting the income.

12. After miners use it for some time, it is acceptable for the hash rate to drop by about 5%.

13. Good miner maintenance will significantly extend the product's service life.

14. IP conflicts may cause IP detection failure.

15. Download the firmware from the official website of Bitmain. Be sure to select the correct firmware. Otherwise, it may change the program and cause malfunctions.

16. Download batch software, connect multiple miners to the same computer for configuration.

17. Due to different algorithms, specific cryptocurrencies can only be mined with specific models of miners.


The content of this article is from the Internet, compiled and edited by ZEUS MINING.


0
About products purchase, please contact our sales manager:
[email protected]

About miner repair and after-sale issues, please contact the repair manager email:
[email protected]

For business cooperation, please contact:
[email protected]

COMPLAINTS & SUGGESTIONS
If you have any dissatisfaction during the transaction or have valuable suggestions for us, please contact us via this email address:
[email protected]
Here is a list of scammers who scamming our customers, if you are chatting with them, please stop chat and let us know immediately:
Telegram:
@Zeusminingcrypto
@ZEUSMININGCRYPTOOFFICIAL
@bearacong

The scammers will change the accounts when they know they are exposed. So please be sure we only have these legal contact accounts which this page: https://www.zeusbtc.com/Contact-us.asp

CLOSE