REPAIR TUTORIALS

Antminer L3 L3+ A3 D3 test fixture production tutorial

20/4/2020

Antminer L3 L3+ A3 D3 test fixture production tutorial

Repairing hash boards and testing fixtures are essential tools. It can quickly and effectively locate the faulty chip, thus getting rid of the bulky oscilloscope.

The principle of the test fixture is: send the test signal to the hash board. If the chip of the hash board is damaged, the test signal will stop transmitting on the chip.

Through the prompt information on the computer screen, we can quickly find the chip, harden or replace it, so as to quickly repair the hash board.

222 (2)_副本.jpg

The test fixture uses the L3 + control board as the main control board

First, we need to prepare a USB to TTL adapter to connect the test fixture and computer, and install the corresponding driver, then we start to make:

① Flash the custom firmware into the flash memory chip of the control board (this flash memory tutorial is issued separately),

②Welding as shown in the figure below

Note: The LCD screen number we use is: HM12864M. If the LCD screen is not sold in your area, you can ignore it because if there is no LCD screen, the test fixture and computer can still maintain normal communication. We can obtain the relevant detection information through the prompt on the computer screen.

222 (1).jpg

Then we need to use the TF card with L3 + test program, insert it into the control board card slot, turn on the power, connect the computer, please pay attention to the prompt on the computer screen, after the test fixture is powered on, it will automatically run the self-test program. It can be used after the self-test.

Please refer to the following article for the connection method:

How to configure the test fixture

If you need to test other miners (the test fixture supports L3 L3 + A3 D3), you only need to copy the configuration file in the download folder directly to the root directory of the TF card and replace the original file in the TF card.

222 (2).jpg

Download link for required files:

Updating ... coming soon




NOTICE
This is an original piece. Reproduction in whole or part without written permission is prohibited.
About miner repair issues, please contact repair manager email:
Repair@zeusbtc.com

For business cooperation, please contact:
Cooperate@zeusbtc.com

COMPLAINTS & SUGGESTIONS
If you have any dissatisfaction during the transaction or have valuable suggestions for us, please contact us via this email address:
service@zeusbtc.com
This web uses "cookies" to give you the best experience. Using this website means you are Ok with this. More info about cookies and how to disable them following this link. I Understand