ZEUS MINING
CRYPTO MINING PRO
Home/REPAIR TUTORIALS/

How to install xshell and connect antminer chips fixture

How to install xshell and connect antminer chips fixture

2020/4/20

How to install Xshell program and connect the antminer chips fixture

To use the test fixture, you need to prepare the following software:

1: Xshell5 or Xshell6Xshell

2: USB to TTL driverUSB driver

We offer downloads:  Xshell download and USB drivers

After unzip the downloaded file, you will get Xshell and USB driver files separately

All we do is install them separately. During this time, please turn off your antivirus software.

First install the USB driver, the following picture can be used as a reference:

install USB driver

Then install Xshell (xshell free download), the following picture can be used as a reference:

(During the installation process, you can choose the language)

install xshell-5

install xshell software

After the installation is complete, connect the USB port of the test fixture to the computer (do not turn on the power), find and record the USB port number in the computer device management.

USB port number

Then run Xshell to start configuring software parameters: 

Please refer to the picture below for the setup steps

Note the key parameters:

1: Port - the corresponding USB port number

2: Baud Rate -115200

3: Terminal Speed -115200

configure xshell parameters

Then turn on the power of the test fixture, and the software starts self-checking. After the self-test is completed, you can use the test fixture to test the hash board.

test fixture self-test

The data shown in this figure takes S9 as an example. Different TF card programs will display different data.

At the same time, XSHELL will also have relevant information prompts. For example, if you see the following page, it means you can test the hash board.

xshell free download

You can check that the device is in good condition by pressing the "Test" button of the test fixture. For example, if there is no Hash board, XSHELL will prompt "NO Hash board".

test fixture information prompt

If a good hash board is attached, a full hash board scan will be performed until the scan is finally completed. But if you insert a damaged hash board, the test will show the serial number of the damaged chip.

So far, congratulations on completing all the test fixture software program configuration and debugging.

Related maintenance tools:

Antminer New version of multi-function test fixture

Official thermoset gel 220g

BM1387 tin tool, high temperature resistant composite material

related articles:

Solution of mixed hashboard miner error

Antminer S9se S9k S11 S15 T15 S17 T17 S17+ T17+ S17E T17E Reasons for not starting

Click to see more miner maintenance tools

NOTICE
This is an original piece. Reproduction in whole or part without written permission is prohibited.
0
About products purchase, please contact our sales manager:
[email protected]

About miner repair and after-sale issues, please contact the repair manager email:
[email protected]

For business cooperation, please contact:
[email protected]

COMPLAINTS & SUGGESTIONS
If you have any dissatisfaction during the transaction or have valuable suggestions for us, please contact us via this email address:
[email protected]
Attention!

Recently, many companies claiming to be mining companies imitate us and say that they are related to us, or that they are our branch companies, which has caused customers to be deceived. Please be careful not to believe any impostors, please check our correct contact information and beware of being deceived getting scammed, and losing money.
please check our right contact way: Here

CLOSE